Surface Treatment VI: Computer Methods and Experimental Measurements for Surface Treatment Effects, Vol. 7
Search in google:
Sect. 1Surface CoatingEvaluation of surface treatment of Ti-6A1-4V alloy specimens3Method to define the batchsize and composition of processes in surface treatment13Modulating CH[subscript 4] flow during the fabrication of improved CVD diamond coatings21Scratching of polymeric coatings: experimental study and mechanical analysis31Adhesive strength of DLC films prepared by ionization deposition41Energetics of aluminium alloys anodization for porous oxide films elaboration51Production of CrN/NbN superlattice coatings by cathode switching reactive cathodic arc evaporation61CFD simulation of an HVOF process for the optimization of WC-Co protective coatings71Basis of high-pressure water-ice jet creation and application for surface treatment85Sect. 2Mechanical Surface TreatmentEffect of shot peening on fatigue strength of maraging steel99Numerical analysis of thermal phenomena and deformations in processing zone in the centerless continuous grinding process109Effect of fine-particle bombardment on fatigue strength of carburized Cr-Mo steel119Regeneration of fatigue properties by methods of surface cold-work hardening129Sect. 3Laser Surface TreatmentLaser melt injection of hard ceramic particles into Al and Ti alloys - processing, microstructure and mechanical behavior141Numerical simulation and microstructural investigation of an aluminum-copper alloy processed by laser surface remelting155Microstructural features in a laser clad TiB-Ti composite coating165The influence of non-metallic inclusions on the strengthening of steels by laser treatment175A numerical solution for non-linear heat flow problem using boundary integral method183Sect. 4Damage MechanicsFatigue behaviour of nitrided low alloy steel in 3%NaCl solution195The influence of fillet rolling on fatigue strength - experiment and calculation205Internal fracture process in fatigue of radical nitrided bearing steel213Fracture mechanism of shot-peened maraging steel in long-life region223On the microstructure and deformation mechanisms under indentations of TiN/(Ti,Al)N multilayer coatings233On the lay selection with determined surface frictional properties243Determination of interface strength of polymer-polymer joints253Effect of fiber length on tensile strength of jute-fiber-reinforced polypropylene with several kinds of interfacial treatment261
